Pizzeria...
Mama Mia!
Pizzeria -
7 x 6 x 6" - $72.98
Supplies by Mayco
SS-108 Light Gray SS-356 Wedgewood
Blue TL-123 Holiday
Red
SS-135 White SS-373 Brick Red
TL-125 Sunflower
SS-135 Flat Black TL-4
Black TL-126
Tangelo
SS-176 Christmas Red TL-8 Nubian
Brown
TL-129 Slate Gray
SS-191 Vanilla Ice TL-107 Antique Ivory
TL-134 Black Forest
SS-192 Light Tan TL-108 Ginger Oak
AC-501 Hi-Gloss Sealer
SS-212 Light Umber TL-113 Hyacinth Blue
AC-516 Porcelain Mist
SS-225 Marigold TL-116 White Cloud
AC-520 Solvent
SS-276 Forest Green
General Directions:
Begin with properly cleaned and fired 06
bisque. Thin down White and apply over entire piece to get into all detail.
When dry, apply another smooth coat of undiluted White. When dry, apply
Hyacinth Blue in small areas wiping back for highlights until entire piece is
covered. Dampen a soft cloth with Solvent to wipe back highlights for an
overall even look to antiquing. Spray with Porcelain Mist to set TL.
Technique
1.
Apply Black TL to cobblestones, roof and side stones at entrance. Wipe
back highlights on stones. Spray. Apply a thin layer of Holiday Red to roof
and sides stones at entrance. Spray. Drybrush roof and side stones with Brick
Red. Highlight with Christmas Red then tip into Marigold to further highlight.
2.
Randomly drybrush a few cobblestones with Light Gray, Light Umber,
Wedgewood Blue and Brick Red. Lightly highlight with Light Gray.
3.
Apply Black Forest to the grass, bottom and base of sign, lower roof eave and 1 part of the
side window sections. Spray. Gently wipe back highlights on grass. Spray.
Highlight grass with Sunflower and Tangelo. Spray. For all other areas,
lightly drybrush with Forest Green then tip into Marigold to lightly highlight.
4.
Apply Nubian Brown to the chimneys and building stones. Wipe back stones
leaving most of the color in the mortar then spray. Drybrush stones with Ginger
Oak. When tacky, wipe back highlights and spray. Randomly drybrush some stones
with Light Tan and Light Umber. Highlight archway stones with Vanilla Ice then
tip into White to further highlight. Drybrush flues with Light Gray then
highlight with White.
5.
Apply Antique Ivory to the entire “pizza” on the main sign and spray.
Use a thin layer of Tangelo on the area where cheese and pepperoni are and
spray. Apply a second layer of Tangelo around the edge towards crust, fading to
the center. Spray. Apply a coat of Ginger Oak to the crust and spray. Apply a
thin layer of Nubian Brown to the pepperonis. Spray. Add a thin layer of
Holiday Red. Spray. Lightly drybrush cheese with Marigold then tip into White
to further highlight.
6.
Apply 2 coats of White Cloud to the widest area of eave, front and back
door, middle windows on sides, middle of main sign and pillars. Spray.
Drybrush with White if needed to even out color.
7.
Apply Holiday Red to remaining window section on sides and line below
pizza on main sign and spray. Lightly drybrush with Christmas Red then tip into
Marigold to highlight.
8.
Apply Slate Gray to the front entrance steps. Wipe back highlights and
spray. Lightly drybrush highlights with White.
9.
Apply Flat Black to the accent pillars, doorknobs, roof trim and
lettering. Apply Brick Red for accents above doors.
10.
Apply Hi-Gloss Sealer to doors, side windows and “pizza.”
