Petro Mold Company

Rock around the clock with this great addition to the 1950's village.  The Stacks o' Wax record shop on main street is where you can get all the new songs!

Mold # 1950 - Record Shop - 5 x 5 x 6" -  $69.98

Supplies by Mayco

SS-16  Angel Blue                    SS-247 Bright Yellow               TL-113 Hyacinth Blue
SS-23  Mink                            SS-317 Turquoise                   TL-116 Cloud White
SS-84  Copper Penny               SS-337  Dark Blue                   AC-501 Hi-Gloss Sealer
SS-92  Royal Fuchsia               SS-356  Wedgewood Blue        AC-516 Porcelain Mist
SS-108 Light Gray                   SS-373  Brick Red                   AC-520 Solvent
SS-135 White                          TL-4    Black
SS-138 Flat Black                     TL-25  Jade Green

General Directions: Begin with properly cleaned and fired 04 bisque.  Thin down White and apply over entire piece to get into all detail.  When dry, apply another smooth coat of undiluted White.  Allow to dry.  Apply Hyacinth Blue in small areas wiping back for highlights until entire piece is covered.  Dampen a soft cloth with Solvent to wipe back further highlights and an overall even look to antiquing.  Spray with Porcelain Mist to set.

Technique

1.      Apply Black TL to the cobblestones and sidewalk.  Wipe back highlights on cobblestones and sidewalk to a dark gray color with Solvent.  Spray.

2.      Randomly drybrush a few stones with Mink, Light Gray and Brick Red.  Lightly highlight sidewalk with Light Gray then tip into White to further highlight.

3.      Use Jade Green on the bricks of the building.  Spray.  Drybrush bricks with Angel Blue.  Tip into White to highlight.

4.      Apply 2 coats of Black TL for roof, remaining window frames, square section of door and upper portion of sign.  Refer to photo as needed for color placement.  Spray.

5.      Use Cloud White for corner columns, window frames, frame around door, trim between floors and “light bar” at roof trim.  Spray.  Except for “light bar,” evenly drybrush all areas and sign detail with White.

6.      Evenly drybrush base of sign and the corner detail of door entrance with Royal Fuchsia.  Paint stripe on upper floor corner detail.  Drybrush detail above door and “wings” on sign with Bright Yellow.  Paint sign lettering with White.

7.      For the “light bar,” detail with Royal Fuchsia, White, Flat Black, Turquoise and Bright Yellow.  Paint column and door frame details with Royal Fuchsia, Turquoise, Bright Yellow and Flat Black. 

8.      Drybrush window frames, record on sign and door with Light Gray.  Lightly drybrush roof and musical notes with Dark Blue then tip into Light Gray to lightly highlight.

9.      Spray entire piece.  Apply 2 even coats of Copper Penny to sign detail, trim under roof, door handles, detail around musical notes and lower portion of building trim.

10.  Apply 2 coats of Hi-Gloss Sealer to roof, record on sign, door trim and musical notes at corner columns.

[Home] 

Contact Us Toll Free - US / Canada:  888-811-6653 

Send email to petro@velocity.net with questions or comments about this web site.
Copyright © 1996-2011 Petro Mold Co.
Last modified: December 31, 2011